|
Post by moparbeppe on May 11, 2011 11:50:49 GMT -5
Hello all
I have bought one of that AMT kits via ebay and now I'm waiting for it to arrive.
Do you know of any problem inherent in the kit /difficulties in building, just to know that beforehand and avoiding mid-building crisis?
Thank you all.
Beppe
|
|
imatt88
Local Delivery Truck Driver
Posts: 30
|
Post by imatt88 on May 14, 2011 21:15:24 GMT -5
mopar, Be prepared for some serious parts cleanup and some vauge parts locations in the instructions.. other than that, its a really nice kit HTH, Cheers, Ian
|
|
|
Post by moparbeppe on May 15, 2011 9:37:59 GMT -5
Thank you imatt88
So nothing special then, usual AMT stuff. Looking at a few builtups I noticed there's a huge gap between cab and bumper. What's wrong there? Too long hinges or too low bumper? And more... there's enough space between engine and cab floor to shorten the hinges if needed?
|
|
Deleted
Deleted Member
Posts: 0
|
Post by Deleted on May 15, 2011 11:28:36 GMT -5
The hinges are actually molded into the frame, but you might be able to raise the part that attaches to the cab (there by lowering the cab) and raise the bumper a little. There's a little room beween the top of the engine & the bottom of the cab, but not much.
|
|
|
Post by slurrydog on May 15, 2011 11:50:09 GMT -5
I am about half way done with my Titan and the only big problem I ran across was the exhaust. But exhaust is always a pain to me it is one of my weak points. Dave
|
|
|
Post by moparbeppe on May 16, 2011 9:22:47 GMT -5
Ok thankyou very much. I'm still waiting for it though... It will be a long wait I think.
|
|