|
Post by rwaldram on Dec 23, 2007 7:17:27 GMT -5
|
|
okdoky
Local Delivery Truck Driver
Keep your knives sharp and your glue lids on
Posts: 365
|
Post by okdoky on Dec 23, 2007 18:58:19 GMT -5
Hi there
Thanks for posting them on here. Great help. I needed detailing on the double steer connection to the non-drive axle of the DROPS and these pics show that principle clearly too.
Great build and Many thanks for showing.
Nige
|
|
|
Post by rwaldram on Dec 23, 2007 19:24:18 GMT -5
i have posted a couple of pics of the KFS twin steer conversion kit in my Crane thread, these pics may also help you to work out connections/steering linkages etc.
|
|
|
Post by rwaldram on Dec 23, 2007 21:31:13 GMT -5
i'm still getting to the simba but basically, if you look at the axles on it the hubs were basically just peices of 'half tube' to cover the outer section of the axle ends, these then had small stubs sticking out of them and the two on the left had steering arms for the linkages. As for the KFS ones, here are two hubs that i have literally just pulled out of the mould, you'll notice that i've been lazy and had the brake actuators glued onto the originals prior to casting
|
|